Eric Praetzel - Film Tests

Goals

I was curious just how much better my pictures would be if I used "professional" film instead of the cheap unbranded films that you get at places like Blacks Camera or Zehrs.
I considered testing Fuji and Agfa films - however, when comparing the technical specs I found the Kodak film to be technically superior with linear response curves. I intentionally choose the NC (Natural Color) film over the VC (Vivid Color) as it should have a wider exposure latitude.

The exact things I wanted to test were:

Summary

  1. This web page is still in construction!!
  2. I could find no difference in sharpness between the films. However, I am limited by the quality of my scanner. I figure that the scanner isn't good enough to show up the grain on 100 ASA film - but, at 1200 dpi scans, the grainyness of 400 ASA is just visable and 800 ASA is clearly visable.
  3. Camera shake did add some slight image blurring at 1/15, 1/30 and 1/60 second exposures. Therefor I would recommend using a tripod for 1/60 sec or less exposures with a 50 mm lens. On a 100 mm lens that would mean that a tripod is useful for 1/125 sec and slower exposures.
  4. The color balance/saturation is quite different for the two films. The Kodak film produces a cooler, less vivid, image - and that is because the other films tend to emphasise color. For wedding pictures I'd probably choose the Kodak film - but I'd have to do a test with the primary wedding colors (black, white and red) to see how saturated red is. On my own wedding pictures the photographer choose a film/paper which really emphasised the reds - but it seems too artifical for my liking.
  5. Exposure latitude - both films have tons of it! If you are over or underexposing by 3 stops - then the image will be effected with a loss of detail and some color change. However, a one stop over/underexposure has no noticable effect. I'd suggest always aiming on the over-exposure side as underexposing more quickly shows grain.

Equipment

Pictures were taken with a Pentax K1000 using a stock 50mm lens. The negatives were scanned at 1200 DPI and a few at 2400 dpi on an HP S20 slide scanner.
The following pictures represent a test of Kodak 160 NC film vs Zehrs bulk film (unbranded Fuji).

Caveats

The following things greatly limit exactly what I'm testing:
  1. All original scans are saved as medium quality JPEG (about 250k for an 1800 x 1200 scan at 1200 dpi).
  2. The scanner is an HP S20. It is only an 8 bit scanner and it didn't take long for me to discover the limits of that. Severely under/over-exposed pictures have more detail than the scanner can extract. As a result prints often look better than scans for images that are over/under exposed.

Sharpness Test & Color Balance

The following pictures were both taken from the same place within a few min. of each other using the same camera and lens. The negatives were scanned at 2400 dpi.
Sharpness comparison(Sharpness summary (1x magnified)

Kodak NC - (c)2001 Eric Praetzel unbranded film - (c)2001 Eric Praetzel

This picture is scanned from the same Kodak NC negative but expanding the saturation to 150%. The unbranded film definately has more "color" to it - but if this is good or bad is upto you!
Kodak NC, saturated 150% at scanning, (c)2001 Eric Praetzel

Motion Blur Test

The camera was hand held at 4 different speeds to see if the shutter lifting and hand holding result in a loss of sharpness. At 1/15 sec I expected to see some blurring.
Note that this was all for a 50 mm lens. If you use a 200 mm lens then expect the pictures to be 4x as sensitive to any motion of the camera. A general rule of thumb is that, for a 50 mm lens, you should use a tripod below 1/60 second.

Summary Motion blur is slightly visable in the 1/15 and 1/30 second exposures.
Camera shake comparison(Sharpness summary (2x magnified)

1/15 sec: (c)2001 Eric Praetzel
1/30 sec: (c)2001 Eric Praetzel
1/60 sec: (c)2001 Eric Praetzel
1/125 sec: (c)2001 Eric Praetzel

Exposure Latitude - Unbranded Zehrs film (Fuji?)

The following pictures go from f2.8 to f16 in the following: f16, f11, f8, f5.6, f4, f2.8 (f8 was the "correct" exposure").
Exposure latitiude comparison(Exposure latitude summary (2x magnified)

(c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel

Exposure Latitude - Kodak 160 NC film

The following pictures go from f22 to f4 in the following: f22, f16, f11, f5.6, f4 (f8 was the "correct" exposure").
(c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel

Depth of Field

The following pictures were shot at different f-stops to see the effect on the depth of field. They were f11, f8, f4
(c)2001 Eric Praetzel (c)2001 Eric Praetzel (c)2001 Eric Praetzel

Playing with Saturation

These two pictures were scans from the same image - the first with the saturation set at 100% while in the 2nd the saturation was raised to 150% in the HP S20 software.
(c)2001 Eric Praetzel (c)2001 Eric Praetzel
Back to my home page