You can use predefined symbols of the form `rnh' and `rnl' to refer to the H8/300 registers as sixteen 8-bit general-purpose registers. n is a digit from `0' to `7'); for instance, both `r0h' and `r7l' are valid register names.
You can also use the eight predefined symbols `rn' to refer to the H8/300 registers as 16-bit registers (you must use this form for addressing).
On the H8/300H, you can also use the eight predefined symbols `ern' (`er0' ... `er7') to refer to the 32-bit general purpose registers.
The two control registers are called
pc (program counter; a
16-bit register, except on the H8/300H where it is 24 bits) and
ccr (condition code register; an 8-bit register).
used as the stack pointer, and can also be called
Go to the first, previous, next, last section, table of contents.